How To Sew A Zipper Pillow Cover

How To Sew A Zipper Pillow Cover. At this point, your pillow should look like this: These are more of an intermediate sewing project, but i promise.

DIY pillow cover with piping and zipper A Lo and Behold Life from www.aloandbeholdlife.com

Place the front panel of the pillow over the back, right sides together; Cut your fabric to size. I bought a few 16″, 18″ and 20″ down pillows and i cut my fabric to the same size, 16″, 18″ and 20″.

Source: www.aloandbeholdlife.com

I bought a few 16″, 18″ and 20″ down pillows and i cut my fabric to the same size, 16″, 18″ and 20″. Sew at 3/8” from the edge.

Source: littleredwindow.com

With a regular foot, and starting at the corner by the zipper, sew around the other 3 sides of the fabrics. Sew the other side of your zipper to you cover.

Source: www.makeit-loveit.com

Flip your pillow cover back over and pin (or don’t pin depending on your comfort level) the other side of the zipper in preparation for sewing down the second side. Make sure to line it up with the basted stitch and pin in place.

Source: www.pinterest.com

Pin together the top edges of the lining front and the top fabric, with right sides facing. Stitch down as you did for the first side of the zipper.

Source: www.whatsurhomestory.com

Here’s the trick to getting a straight zipper. Pin to keep the pieces in place.

Source: www.womansweekly.com

Now you’re ready to sew your bottom edge. You can create a paper pattern cut at 19” x 19” for this if you plan to make multiples.

Source: mostlysewing.com

You’ll want to sew this side first. Remove the pins and fold the flap back over the zipper.

Source: blog.treasurie.com

Pin together the top edges of the lining front and the top fabric, with right sides facing. This pillow will finish at 18” so the 19” cut gives you a one half inch seam allowance on all sides.

Using A Zipper Foot, Stitch The Zipper To The Top Of One Panel.

If you already have a pillow cover, take that out, measure across to know the size. Here’s the trick to getting a straight zipper. You’ll want to sew this side first.

Again With Your Needle Down Into The Fabric.

Set up your ironing board. This will keep the fold flat. Place both squares on top of each other again, right side in.

How To Sew A Pillow Or A Zipper On A Pillow Cover.

Sew the top and bottom of zipper to secure in place. Turn pillow cover right side out, insert pillow form and celebrate! Make sure you sew through the zipper ends as well.

Unzip A Little To Get Started.

Sew 5/8 of an inch from the edge of the pillow to the pin marking where the zipper stopped. Place the front panel of the pillow over the back, right sides together; The zipper will now be between the top panel and the lining.

Open Zipper And Sew The Three Remaining Seams Using A Half Inch Seam Allowance.

Switch to your zipper foot to sew a straight line down along each side of your zipper (4th and 5th photos below, look carefully for the seam!). The picture below can be a. Trim the thread and find the side with the closed zipper pull.